Loading...
FiberPlex Fiber Optic Remote for Exelis RO Tactical Radio PKG-CCRP

FiberPlex Fiber Optic Remote for Exelis RO Tactical Radio PKG-CCRP

SKU: 1478 Categories: , , Tags: , , , , ,
Brand: Fiberplex

$8,658.10

Description

Overview

Overview

The PKG-CCRP is a two part solution providing a fiber optic remote extension of the Exelis RO™ Tactical Radio handset / data port to a desk set monitor. The solution allows the radio to be mounted in a convenient location to allow a shorter permanent antenna cable, maximizing the signal strength, while allowing the radio to be used in a location where it may not normally function.

>The 2U high rack mount chassis provides power regulation for the radio, local connector access for install verification/configuration/monitoring, and a fiber optic interface for remote connection of the radio accessory port. All installed devices are modular and can be easily accessed from the rear of the chassis. Front panel LEDs show system power and radio PTT status.

The desk set monitor provides for connections of the same radio accessories (handset, headset, PDA device, etc.) as well as a separate rear serial port (standard 9 pin connector) for connection to a PC or other serial device while allowing for monitoring of incoming audio via the desk set speaker. Separate volume controls allows adjustment of the handset volume apart from the monitor speaker volume. The monitor speaker has a mute control, allowing quick silencing of the speaker without having to adjust the volume. LED indictors show the monitor speaker mute status as well as fiber link status. The rear serial port allows simultaneous data and audio use.

PKG-CCRP Rear

Additional information

Weight 5.00 lbs
Dimensions 5.00 × 5.00 × 5.00 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Features

Radio Rack (RMC-CCRP):

  • Provides housing and power for an Exelis RO™ Tactical Radio
  • Hot Swappable Redundant Power Supplies
  • Supports all functions of the RO ™ Tactical Radio including PTT and serial data connection
  • Front panel access for local handset connection
  • Local / Remote selector
  • Status indicators
  • Includes all radio connections
  • Easy access for external antenna connection

Desktop Remote (CCRP-B):

  • Full handset support
  • Built-in speaker for audio monitoring
  • Separate volume control for handset and speaker
  • D9 Serial port connector for remote radio monitoring

Specifications

AUDIO SPECIFICATIONS (FOI-7280)
  Min Typ Max unit
Frequency Response 20 Hz to 25 KHz -0.5 0 0.5 dB
26 KHz to 45 KHz -1.5 0 1.5 dB
Third Harmonic Distortion plus Noise (THD+N)* – 1 KHz @ +4 dBu – 0.015 – %
Input Level (with max 1% THD) -60 0 +17 dBu
  –   VDC
Input Sensitivity 0.020 0.775 7 Vrms
Input Noise Floor ref +0 dBu – -80 – dBu
Input Impedance – 2 – KO
Output Level 0.02 0.775 7 Vrms
Output Impedance – 150 – O
Output for Use with Nominal – 600 – O
Audio Latency (point to point) – 1260 – µs
Sampling Rate 24 bit / 96kHz or 24 bit / 48 kHz
*Hum & Noise are measured with an AES17 compliant filter at 20 kHz. Temperature condition @+10 – +25° C.
SERIAL DATA SPECIFICATIONS
Min Typ Max unit
RS-232 Output Levels, 3KO Termination ±5 ±5.4 – VDC
Input Levels -15 – +15 VDC
Input Threshold ±3 – – VDC
Data Rate 0 – 1 Mbps
Input Termination 3 – 2.3 KO
ELECTRICAL SPECIFICATIONS
Min Typ Max unit
Environmental Storage Temperature (°C) -40 – 85 °C
Operating Temperature (°C) 0 – 50 °C
Power Requirement Voltage Range 7 9 12 VDC
Supply Current, no SFPs – 600 – mA
OPTICAL SPECIFICATIONS
External SFP Interface Min Typ Max unit
Data Rate – 346 – Mbps
Recommended Jitter – 40 – psec
Operating Voltage – 3.3 VDC
Maximum Current – – 500 mA
Optical Modules SFP MSA (SFF-8431, SFF-8432, SFF-8433) compliant slot, data rate 266 Mbps – 1.25 Gbps
Output Power (50µ fiber) -9 – -4 dBm
Extinction Ration 9 – – dB
TX Optical Wavelength 830 850 860 nm
RX Sensitivity – – -18 dBm
Max Received Power 0 – – dBm
RX Optical Center Wavelength 770 – 860 nm
The CCRP is optimized for 50 micron multimode fiber. This will allow a link up to approximately 2 km, depending on cable grade, number of splices or patch panels, etc. When using 62.5 micron fiber the maximum distance for a link with the CCRP is approximately 1.8 km.

Ordering Information

 

PKG-CCRP